Andreja Premium: How to remove the outer shell?

"IMPORTANT: Unplug the machine when making this adjustment. Turning it off at the switch isn't enough—unplug it.



Remove the top cover and take out the two screws.


Remove the water tank and take out the two screws that hold the back panel.


Remove the drip tray and take out the two counter sunk screws on both sides (left and right).


Pop the back panel off. The bottom is not screwed on; it pops off and on.

   
After the back panel is off, take out the two screws.


You now have all the screws out and are ready to remove the shell in one piece. This part is a little tricky; it's almost like you need another hand. Take hold of the shell at the top and the bottom on the opposite side and spread the side panels apart and slip it up and over the machine. Be careful not to spread it too much or you will dent the top of the machine where the rail is attached. You might want to loosen the allen screws a little that hold the rail on before attempting to take the shell off. Only loosen them slightly to make it easier to spread the shell and not dent the top.
"

Leave a comment

Please note, comments must be approved before they are published